|
Thank you for choosing from the Quick Stick range of
unique and innovative percussion accessories, designed
to give you many years service.
The Quick Stick - Stick Holder enables quick replacement
or selection of spaced apart drumsticks, mallets, beaters
etc, from your preferred ideal position and angle.
Adjustment to suit the style of stick being used:
Using only a rounded, blunt ended
tool i.e. butt end of a drum stick, the position of
the black plastic Stick Stoppers (supplied) can be adjusted
to allow you to choose the optimum depth so the sticks
can be easily removed without snagging and do not wobble
excessively. Always place sticks in the hollow part
of the Stick Stopper.
For the holes with reduced
ends use a smaller suitable tool (say, 7mm in diameter
with a small handle) to push through the reduction to
adjust the Stopper. Keep a few spares handy when setting-up/playing.
To adjust or remove stick stopper from tubes 1, 2 &
3, push the stopper cap end down.
Fixing options
For mounting purposes the reduced internal diameters,
at the base of the 2nd and 4th holes of the Quick Stick
-Stick Holder, can accept commonly available generic
L-Arms of both diameters. Simply clamp the Quick Stick
- Stick Holder to hardware on your kit, just where you
need it (pic 1).
To position
the Quick Stick - Stick Holder a little further away
from you (e.g. to prevent sticks interfering with play
above the snare drum when fixed to a bass drum post).
Use the Quick Stick -Stick Holder in upside-down
(reverse) mode i.e. so the two reduced diameter ends
are facing you (pic 2). This still allows 1-3 sticks
to be held.
Remove the stopper
from hole 2 or 4 and push an L- Arm inside through chosen
tube, then into the reduced end (remember to turn the
Stick Stoppers round in the middle and two outer tubes!).
The Quick Stick - Stick
Holder can also be fitted into some double braced legs
of stands used on a drum kit e.g. hi-hat (pic 3). Place
the stick stopper near the top of the end tube being
pressed into double braced leg to allow a secure fixing.
Still holds 1-4 sticks.
Fixing to a floor tom leg:
Remove leg, attach a clamp to
lower section of it, then reattach to drum and use in
upside-down mode (pic 4).
When used in a downward angle:
It is advisable to check the
angle used (maximum 45 degrees downward angle) as excessive
vibration may cause the sticks to inadvertently fall
if the angle is too steep.
Best results are achieved
with the Quick Stick - Stick Holder on a separate stand
when angled downward.
Being made from
high grade silicone means the Quick Stick - Stick Holder
can easily be cleaned using diluted washing up liquid
(when washed, just rinse, dry, and refit to drum kit). |
